@article{Borutzky2012,
  author    = {Wolfgang Borutzky},
  title     = {Bond-graph-based fault detection and isolation for hybrid system models},
  series   = {Proceedings of the Institution of Mechanical Engineers, Part I: Journal of Systems and Control Engineering},
  volume    = {226},
  number    = {6},
  publisher = {Sage},
  issn      = {0959-6518},
  doi       = {10.1177/0959651812440665},
  url       = {https://nbn-resolving.org/urn:nbn:de:hbz:1044-opus-8962},
  pages     = {742 -- 760},
  year      = {2012},
  abstract  = {For the case when the abstraction of instantaneous state transitions is adopted, this paper proposes to start fault detection and isolation in an engineering system from a single time-invariant causality bond graph representation of a hybrid model. To that end, the paper picks up on a long-known proposal to model switching devices by a transformer modulated by a Boolean variable and a resistor in fixed conductance causality accounting for its ON resistance. Bond graph representations of hybrid system models developed in this way have been used so far mainly for the purpose of simulation. The paper shows that they can well constitute an approach to the bond-graph-based quantitative fault detection and isolation of hybrid models. Advantages are that the standard sequential causality assignment procedure can be a used without modification. A single set of analytical redundancy relations valid for all physically feasible system modes can be (automatically) derived from the bond graph. Stiff model equations due to small values of the ON resistance in the switch model may be avoided by symbolic reformulation of equations and letting the ON resistance of some switches tend to zero, turning them into ideal switches. First, for two examples considered in the literature, it is shown that the approach proposed in this paper can produce the same analytical redundancy relations as were obtained from a hybrid bond graph with controlled junctions and the use of a sequential causality assignment procedure especially for fault detection and isolation purpose. Moreover, the usefulness of the proposed approach is illustrated in two case studies by its application to standard switching circuits extensively used in power electronic systems and by simulation of some fault scenarios. The approach, however, is not confined to the fault detection and isolation of such systems. Analytically validated simulation results obtained by means of the program Scilab give confidence in the approach.},
  language  = {en}
}