Refine
H-BRS Bibliography
- yes (10)
Departments, institutes and facilities
- Fachbereich Angewandte Naturwissenschaften (10) (remove)
Document Type
- Article (5)
- Conference Object (2)
- Research Data (1)
- Doctoral Thesis (1)
- Report (1)
Has Fulltext
- no (10) (remove)
Keywords
- Crystallinity (3)
- Complex modulus (2)
- Extrusion blow molding (2)
- extrusion blow molding (2)
- Biaxiality (1)
- DMA (1)
- DSC (1)
- Draw ratio (1)
- Dynamic mechanical analysis (1)
- Flow direction (1)
Process-dependent thermo-mechanical viscoelastic properties and the corresponding morphology of HDPE extrusion blow molded (EBM) parts were investigated. Evaluation of bulk data showed that flow direction, draw ratio, and mold temperature influence the viscoelastic behavior significantly in certain temperature ranges. Flow induced orientations due to higher draw ratio and higher mold temperature lead to higher crystallinities. To determine the local viscoelastic properties, a new microindentation system was developed by merging indentation with dynamic mechanical analysis. The local process-structure-property relationship of EBM parts showed that the cross-sectional temperature distribution is clearly reflected by local crystallinities and local complex moduli. Additionally, a model to calculate three-dimensional anisotropic coefficients of thermal expansion as a function of the process dependent crystallinity was developed based on an elementary volume unit cell with stacked layers of amorphous phase and crystalline lamellae. Good agreement of the predicted thermal expansion coefficients with measured ones was found up to a temperature of 70 °C.
Influence of design of extrusion blow molding (EBM) in terms of extrusion direction set-up and draw ratio as well as process conditions (mold temperature) on storage modulus of high density polyethylene EBM containers was analyzed with dynamic mechanical analysis. All three parameters - mold temperature, flow direction and draw ratio - are statistically significant and lead to relative and absolute evaluation of storage modulus. Furthermore, flow induced changes in crystallinity was analyzed by differential scanning calorimetry. Obtained data on deformation properties can be employed for more sophisticated finite element simulations with the aim to reach more sustainable extrusion blow molding production.
Introduction of Matrix-Filler Adhesion to Modelling of Elastic Moduli of Particulate Composites
(2022)
Cube in cube elementary volume (EV) concept serves to predict a filler-content dependent Young´s moduli of particle filled composites using moduli of a matrix EM and a filler EF. Paul and Ishai-Cohen derived formulas for composites moduli considering different load transfer boundaries in the EV assuming a complete filler-matrix adhesion. In this paper it is confirmed that their models represent the upper and lower bounds, respectively, with the respect to the experimental data. However, in vast majority of composites a filler-matrix adhesion is not complete. Therefore, an adhesion factor kadh gaining values between 0 and 1 was introduced into Paul´s model to consider the reduced adhesion as the reduction of the filler-matrix contact area for glass beads filled in polar and unpolar thermoplastic matrices as well as elastomer. The evaluation of these composite systems provides reasonable adhesion coefficients of PA66 > PBT > PP > PE-LD >> BR. It was also found that stiffening only occurs if kadh exceeds the minimum value adhesion of root square of E(M) divided by E(F). The determined kadh correspond to scanning electron microscopy observations of the composites fracture surfaces. Additionally, finite element analysis of the cubic and hexagonal arrangements of the EV show that the stress distributions are different, but they affect the calculated moduli only for the filler volume contents exceeding 20 %. The introduction of the filler-matrix adhesion provides more reliable predictions of Young´s moduli of particulate composites.